Main
Parameters:
Type
|
WK-WST-60A
|
WK-WST-40A
|
WK-WST-30A
|
WK-WST-20A
|
|
Sustaining voltage |
6-25V
|
6-17V
|
6-17V
|
6-17V
|
| BEC
current |
3.0A
|
3.0A
|
3.0A |
3.0A |
| Continuous
output current |
60A
|
40A
|
30A
|
20A |
| Instant
max current |
80A
|
60A
|
50A
|
40A
|
| Inside
impedance |
0.0022
O |
0.0033
O |
0.0044
O |
0.0066 O |
| Reversion
|
Yes
|
Yes
|
Yes
|
Yes
|
| Low
voltage, cut electricity protection |
Yes
|
Yes
|
Yes
|
Yes
|
| Weight
|
35g
(approximately) |
33g
(approximately) |
32.4g
(approximately) |
31.8g
(approximately) |
When
the controller signal lose, it will stop automatically. But it will come back
to the former mode at once when it receives the signals. It can be used for
electric planes, helicopters. And it can be positive and reverse by adjusting
the motor lines.
Introduction
in using:
1.please
insert the signal lines in correct direction to the controlling output port
of the controller.
2.please
connect well the three output ports of the activator suitably to the three
input ports of the brushless motor.
3.please add the relevant voltage
to the electricity input port of the activator(please be sure the positive
and negative poles are right),and you can hear a sound
beep¡±.When you push the throttle
rod, the motor will turn at once. If the motor turning the reversing direction,
you can exchange any two of the three lines and it will be OK.
WARNING:
If the using current of the BEC over the rating, we advise you use extra BEC.
Or it will damage the activator.
Do
as the sketch map:
Trouble
diaganosing:
Phenomena
|
Reasons
|
Resolution
|
|
The motor don't turn after connecting electricity |
1.There is something wrong with the plug of the electricity
2.The battery's voltage is too low, circuit protection
3.Transmitter rod isn't in the lowest position, circuit protection
|
1.Reinserting the plug of the electricity or changing a new one
2.Charge the battery fully.
3.Push the transmitter rod to the lowest position.
|
Motor running reversed
|
1.Connection the three output ports not correctly to the suitable three
input ports of the brushless motor. |
1.Exchanging the two of the three lines and it will be OK.
|
Stopping in midway
|
1.The battery voltage is too low, circuit protection.
2.There is something wrong with the pin, cutting electricity.
3.The output ports and motor not connect well.
4.Receiving signals break off.
|
1.Charge the battery fully.
2.Reinsert the plug of the electricity or change a new one.
3.Check the transmitting and receiving; repair the signals to communicate
normally.
|
| Hear
a "beep" sound but the motor not running |
1.Transmitter rod is not in the lowest position, circuit protection.
2.The output ports not connecting well with the motor.
|
1.Push the transmitter rod to the lowest position.
2.Reinsert the plug of the electricity or change a new one.
|
|
